HP MSM 460 Dual Radio 802.11n AP (AM)
=================================
Critical software update required (controlled mode)
(Applies to E-MSM430, E-MSM460, and E-MSM466 operating in controlled mode only.) The flash boot section of these APs can become corrupted over time, resulting in a boot up issue. It is critical that you update your MSM7xx series controllers to version 5.5.2.0 or greater to prevent this issue.
NOTE: This software is being provided for entitled customers only. Only customers who have purchased MSM430, MSM460 or MSM466 Access Points or those customers who have software entitlement contracts covering the products listed below should download this software.
If you are not entitled to this software and you choose to download/install it anyway, you are violating the terms of the End User License Agreement. Installing this software does not create any right for you to utilize customer support. Only customers that are legally entitled to this software are also entitled to customer support.
About controlled mode and autonomous mode
The AP can operate in one of two modes: controlled (the default) or autonomous.Switching modes resets all configuration settings to factory defaults.
•Controlled mode: To become operational, the AP must establish a management tunnel with an MSM7xx Controller. The controller manages the AP and provides all configuration settings. Discovery of the controller is automatic if default settings are used on the AP and the controller, and both devices are on the same subnet. See Working with controlled APs in the MSM7xx Controllers Configuration Guide.
•Autonomous mode: After being switched to autonomous mode, the AP operates as a stand-alone AP. You configure and manage an autonomous AP by using its Web-based management tool,
=================================
Critical software update required (controlled mode)
(Applies to E-MSM430, E-MSM460, and E-MSM466 operating in controlled mode only.) The flash boot section of these APs can become corrupted over time, resulting in a boot up issue. It is critical that you update your MSM7xx series controllers to version 5.5.2.0 or greater to prevent this issue.
NOTE: This software is being provided for entitled customers only. Only customers who have purchased MSM430, MSM460 or MSM466 Access Points or those customers who have software entitlement contracts covering the products listed below should download this software.
If you are not entitled to this software and you choose to download/install it anyway, you are violating the terms of the End User License Agreement. Installing this software does not create any right for you to utilize customer support. Only customers that are legally entitled to this software are also entitled to customer support.
About controlled mode and autonomous mode
The AP can operate in one of two modes: controlled (the default) or autonomous.Switching modes resets all configuration settings to factory defaults.
•Controlled mode: To become operational, the AP must establish a management tunnel with an MSM7xx Controller. The controller manages the AP and provides all configuration settings. Discovery of the controller is automatic if default settings are used on the AP and the controller, and both devices are on the same subnet. See Working with controlled APs in the MSM7xx Controllers Configuration Guide.
•Autonomous mode: After being switched to autonomous mode, the AP operates as a stand-alone AP. You configure and manage an autonomous AP by using its Web-based management tool,
